Gun Forums banner
1 - 11 of 11 Posts

· Registered
Joined
·
884 Posts
Discussion Starter · #1 ·
is it possible to find a AK Parts kit and receiver at a CA gun show? i was just wondering cause of laws and all of that great stuff.. and on receivers is there any checks or waiting periods?

reason behind all of this im going to a gunshow sunday and i wana know how much money to bring
 

· Registered
Joined
·
138 Posts
As I am sure you know, if you are able to order online, a Romy G will set you back ~$100-$130. I've seen the exact same kits at shows for ~$150-$170. However, at the same table were Tapco flats for $15. That was a value deal.

The good rule of thumb for any gunshow however is take as much money as you can bear and an open mind on what you'll buy. It always seems when I've gone with the strict plan on buying a specific firearm or part, it is either absent or overpriced. If I just go with the flow, I find deals.

Good Luck & report back.
 

· Registered
Joined
·
884 Posts
Discussion Starter · #7 · (Edited)
so this is how it went down.....

i had to wait all day on SAT and most of the day on SUN to sell my dirtbike. i got to the gun show at 4:00 pm and everone was packing up. i went up to a gun seller and asked if he had any Mossberg 500's and he said this " yes but they are all packed up and gone already...should of got here sooner " but he said this very snotty. so i walked out the door of the gun show with $900 cash. i felt so bad because this was the 1st gun show i have been to when i was 18.


so i have 900 bucks...Krinkov here i come.....BTW does anyone know if this company is trust worthy?
http://www.nodakspud.com/page2.htm
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top